Before You Return

Most Faro-Dock problems take about two minutes to fix. Before you request a return, please run through the checks below. They cover nearly every issue our customers run into: slow charging, a phone that won't stay on, or a dock that feels loose.

1. Try these quick fixes first

Not charging, or charging slowlyThe most common issue, and usually the easiest fix
  1. Check the port. 2027+ Telluride: your Telluride has three USB-C ports. Only the ones marked with a small lightning bolt put out enough power. Plug the dock into one of those. 2020–2025 Telluride: make sure the included 12V adapter is pushed all the way into the 12V socket. Test the socket with another device.
  2. Turn the vehicle on. Some ports only give full power with the vehicle running or in accessory mode.
  3. Make sure it sits perfectly flat. The back of your phone has to rest flat against the charger's magnetic face. If it's tilted or lifted even slightly, the phone can charge slowly or not at all. Press it on until the magnet grabs and the phone is flush.
  4. Check for a raised camera ring on your case. Thick cases with a raised lip around the camera can lift the phone off the charger, especially when the camera sits near the charger's edge. If your case has one, try a different plate height or a slimmer case.
  5. Take the case off and test. Set your bare phone on the dock. If it charges faster without the case, the case is the problem: it's too thick, or its magnet ring is weak or sits in the wrong spot.
  6. Use a slim Qi2 magnetic case. Thick, rugged or wallet cases put too much space between your phone and the charger. Samsung Galaxy phones need a Qi2 magnetic case to charge at full speed. Shop slim magnetic cases.
  7. Check your phone. Charging speed depends on your phone. Some phones top out well below 25W. Search for yours on our Phone Compatibility page.

Phones also slow down charging on their own when they get hot, for example in direct sun or while running navigation. That's normal and not a dock fault.

Phone won't stay on, or slides offUsually the case, the seating or the plate height
  1. Seat it fully. Press your phone flat against the charger until the magnet grabs. The phone should sit perfectly flat on the magnetic face, not tilted or resting on its edge.
  2. Do the table test. Take the top plate out and set your phone on it on a table. If the phone won't hold there, the problem is your phone or case's magnets, not the install.
  3. Check the camera bump. On some phones, the camera bump or a thick case's raised camera ring hits the plate before the magnets meet, which lifts the phone off the charger. Try a different plate height (see below) or a slimmer case.
  4. Adjust the plate height. The top plate has four positions (A1, A2, B1, B2). Most phones fit the standard A2. If your phone hits the dash at the top, move to a lower position. If it hits the console at the bottom, move higher. The steps are in your install guide.
Dock feels loose, moves or rattlesAlmost always an assembly or install step
  1. Remove the factory mat(s). The dock has to sit directly in the tray. A mat left underneath will keep it from locking in.
  2. Check the orientation. "FRONT" is marked under the base plate and on the supports. Front is the side closest to the driver.
  3. Rear hooks first. 2027+ Telluride: hook the rear in first, center the dock left to right, then press down on the front clips until you hear a click.
  4. Check the clips. Every support clip must be fully in slot 1 or slot 2, never between them. Look for a cracked or broken clip.

Please don't force it. Pressing too hard or in the wrong spot can break a clip. If a clip is broken, email us and we'll sort out a replacement part.

Full steps with pictures: Install Guides.

Phone or case doesn't fitSize and clearance
  • The dock fits phones up to 6.5 inches tall with the case on.
  • Thick or rugged cases may not clear the dash and console. A slim case usually fixes it.
  • Try a different plate height (A1, A2, B1, B2) before deciding it doesn't fit.
  • Check your phone on our Phone Compatibility page.

A phone or case that doesn't fit isn't a defect. If it still doesn't work for you, you can return it under the normal terms in step 3.

Still not working?

Pick the option that matches your situation.

2. Defective or damaged

Email us first. Don't request a return yet.

  • Broken or cracked parts, a charger that won't power on in any port, damage in shipping, or the wrong item.
  • Email within 7 days of delivery, with photos or a short video.
  • Tell us which of the quick fixes above you've already tried.
  • If we confirm a defect, we'll send a replacement or a full refund including shipping, and we cover return shipping.
Email us about a defect

info@farodock.com · (864) 261-1023

3. Not defective

Changed your mind, or it isn't right for you?

  • Request a return within 30 days of delivery. Sign in, open your order and choose Request return.
  • Item must be in original condition with every part included.
  • Shipping costs are non-refundable. Original shipping isn't refunded, and you pay for return shipping.
Example: Dual Station at $59.99 plus $10 shipping
Product price $59.99
$10 shipping not refunded
Your refund $59.99
You also pay to ship it back to us.
Sign in and request a return

Custom-color docks and phone cases are made to order and can't be returned unless they arrive damaged or defective. See our full Return Policy.